Common main condition, which must be respected regardless of the means is the selection of a suitable color. Otherwise, all efforts to remove external defects may be in vain. Junk CASTLE If you have happened any malfunction with the door locked, it is first necessary to ascertain the reasons. First try to open and close a few times when the open state locking steel door. If in such a position lock function normally, the cause is likely in a hole under the crossbar. The fact is that over time, the door may be slightly prosest and, accordingly, the level of bolts and holes are no longer the same. In this case, you can either fix skewed door, or a little "pomudrit" with holes for the course of crossbars. As a working tool, you can use the file.

But before you mindlessly file down the surface of the holes for the bolts, it should be noted place to study. To do this, your regular toothpaste or other alternative means, which would have a contrasting color, and could then easily slip away. Paste deposited on the end of the coming out of the lock bolts, and they will be partially closed, rests against the side profile frame and leave her mark. If the lock pink even when the steel door open state, then the fault is probably in the core, so it is recommended simply replace it with a new one. One of the contraindications for damage to the lock can be assumed that under no circumstances should one try to crank the power key as it threatens dire consequences – a key failure in the core.

A This in turn complicates the repair of the castle, and his efforts can not cope. DONKEY DOOR If at closing the door leaf with difficulty comes in the door frame, or in some way distorted, then it is necessary First of all, check out the loop: more tightly wrap the bolts. DOOR BELL DOES NOT WORK Not all holders entrance steel doors possess sufficient information about the fittings, which she completed, so some of the problems may arise simply because of ignorance. The most common problems that happens with the fittings, is that after awhile doorbell stops working. And before you throw out the old and acquire new, should be more closely examine its structure. Doorbell, which is equipped with a steel door is wired. In other words, a button which is located on the surface of the door, and the body of the bell, which is located in the interior of the door frame, connecting wires. Power supply are two penlight batteries, which are located inside the housing. The conclusion is clear: first of all, try changing batteries. To do this you only need to be removed from the doorframe casing bell and open the lid, under which both are old batteries. For more information, go to the site